If your Pirate MIDI devices aren't working as expected and the User Manuals and YouTube Channel aren't giving you the answer, please Contact us.
The first step in troubleshooting any update problems (before or after an update) is to Factory Reset your device. (Make sure to backup your config first)
Bridge6
Hold FS1 down and then power on your device. Hold for about 7 seconds until all LEDs go white, then release the footswitch.
Bridge4
Hold FS3 down and then power on your device. Hold for about 7 seconds until all LEDs go white, then release the footswitch
Aero
Hold Switch A down and then power on your device. Hold for about 7 seconds until all LEDs go white, then release the footswitch
If the device successfully reboots and goes to the main screen, test the problem again. If it persists, contact us or post in the Support Forum on Discord.
If your BRIDGE controller is not able to be updated using our firmware updater app for some reason, or your device appears to be dead (no screen and no LEDs after plugging in), you will need to perform a manual firmware update.
Perform a manual firmware update following the instructions in these PDFs. If you don't know the hardware version of your device, you'll need to Contact Us.
If your Aero is not able to be updated using our firmware updater app for some reason, or your device appears to be dead (no LEDs after plugging in), you will need to perform a manual firmware update.
Perform a manual firmware update following the instructions in this PDF.
This means the incorrect firmware version for your hardware version has been installed. This is only possible by manually installing firmware and installing the wrong firmware version.
To remedy this, perform a manual firmware update following the instructions in this PDF. If you don't know the hardware version of your device, you'll need to Contact Us.
This means the incorrect firmware version for your hardware version has been installed.
To remedy this, perform a manual firmware update following the instructions in this PDF. If you don't know the hardware version of your device, you'll need to Contact Us.
The fix for this is to Factory Reset your device.
Hold FS1 down and then power on your device. Hold for about 7 seconds until all LEDs go white, then release the footswitch.
If the device successfully reboots and goes to the main screen, hooray! If some UI elements are still missing, please update your firmware.
The main fix for this is to Factory Reset your device.
Hold FS1 down and then power on your device. Hold for about 7 seconds until all LEDs go white, then release the footswitch.
If the device successfully reboots and goes to the main screen, hooray! If the boot loop continues, please Contact Us.
